* Heating element gently warms the toes and surrounding area, as these are the parts most susceptible to cold
* Insoles can remain warm for up to 7 hours, depending on selected temperature setting. This time can
be dramatically increased by switching them on for short bursts
* Three heat settings so you can select the temperature best for you
* Battery is incorporated into insole, with no dangling cables or unwieldy boxes
* Convenient socket located in heel - no need to remove the battery in order to recharge
* Easy-to-use remote control key-chain in order to switch on/off, or flick between heat settings
* Can be trimmed to size in order to get the best fit
* Insoles can remain warm for up to 7 hours, depending on selected temperature setting. This time can
be dramatically increased by switching them on for short bursts
* Three heat settings so you can select the temperature best for you
* Battery is incorporated into insole, with no dangling cables or unwieldy boxes
* Convenient socket located in heel - no need to remove the battery in order to recharge
* Easy-to-use remote control key-chain in order to switch on/off, or flick between heat settings
* Can be trimmed to size in order to get the best fit
Small
EUR: 36 - 39, UK: 5 - 7, USA 5 – 8, Aust. Men's 3 - 7.7 (23.5cm - 27cm)
Large
EUR:40-48, UK: 7-14, USA: 9-15 Aust. en's 7 - 13 (27cm –31cm)
EUR: 36 - 39, UK: 5 - 7, USA 5 – 8, Aust. Men's 3 - 7.7 (23.5cm - 27cm)
Large
EUR:40-48, UK: 7-14, USA: 9-15 Aust. en's 7 - 13 (27cm –31cm)
Voltage: 3.7V
Current Capacity: 1800mA
Charging voltage: 3.0V-4.2V
Power Output Efficiency: ≥98%
Over-charging Protection Voltage:
Current Capacity: 1800mA
Charging voltage: 3.0V-4.2V
Power Output Efficiency: ≥98%
Over-charging Protection Voltage:
High mode: 60 Degrees - 3-4 Hrs Working time
Med mode: 50 Degrees - 5-6 Hrs Working time
Low mode: 40 Degrees - 6-7 Hrs Working time
Med mode: 50 Degrees - 5-6 Hrs Working time
Low mode: 40 Degrees - 6-7 Hrs Working time
Charging time is around 4 hours
To charge, you must insert the two lines of the charger into the DC---the bottom of the heated insole. The 'Red' LED light symbolises 'charging' and will display a 'Green' LED when fully charged
To charge, you must insert the two lines of the charger into the DC---the bottom of the heated insole. The 'Red' LED light symbolises 'charging' and will display a 'Green' LED when fully charged